Corrected problem where when doing node editing Online, and editing the last network and entering in branches in a cell location prior to downloading a contact already in that cell, would eventually cause an "Error Writing Node to PLC", and put the PLC in STOP.
Corrected problem where Cutting/Pasting in a 5-digit program with shared documentation, the pasted doc did not print.
Corrected problem where invalid addresses in the doc window were not allowed to be deleted.
Corrected problem where attempting to force an element when memory protect is on gave no error message.
Corrected problem when Pasting with Rewire in continuous mode, the pasted logic was placed in the last configured segment regardless of the intended paste location.
Corrected problem where saving an online program from a 984A-S901 to disk and opening that program offline, the PLC Type and Memory Size combo boxes in the PLC Type Setup dialog were blank.
Made modification where when going online with a PLC which contains no logic, an "Error while attempting to display logic." Error appeared. The text of the error message was changed to "The PLC currently contains no logic."
Corrected problem when displaying the 'Copy' dialog from the Doc Window, the static text within the dialog says 'Merge Program Merge Program' instead of 'Copy Range'.
Corrected problem where Undoing a node edit Online, the "edit" stays on the title bar. This happened for any segment other then 1.
Corrected problem where when Online entering a NO or NC contact and typing an address, and without pressing enter, select F9 (Branch Down hot key) the address is cleared.