Solutions
- The CDB instruction now correctly checks the value of the address.
- The PID Loop Ramp/Soak Profile now properly restarts operation when the Loop Ramp/Soak number is manually reset to 0.
- The CTR instruction’s output no longer turns off when the count no longer matches the preset.
- MOD instructions are now properly evaluated within IF statements in a Special Function program.
- NOT instructions now operate correctly in parallel branches when passing power flow.
- B-memory parameters are now properly allowed in CMP instructions.
- Nested MCR instructions now operate correctly.
- Attempting to set an LTI variable to zero in the Data Window now properly displays an error.
- B-memory is now properly supported in the MIRW instruction.
- Special Function clamping for PID Loops and Analog Alarms is now consistent between 505 and CTI 2500 PLC types.
- Attempting to execute a network containing more than 16 parallel branches no longer results in an error.
- Analog Alarms are now set and reset correctly when the alarm deadband overlaps low/high alarm points.
- One-shot contacts no longer automatically execute after an online edit is made.
- Multiple instructions that use B and W addresses now execute properly.
- Special Function programs are no longer triggered when the input conditions are false.
- Cyclic Special Function programs now properly stop executing after changing to inline while online with the controller.
- Cyclic Special Function programs now properly stop executing when ‘Continue on Error’=NO.
- Address breakpoints are now properly being triggered by coil instructions.
- The PACK statement now executes properly when moving Loop and Alarm CF variables to and from Bit memory.